So which proto are you MOST pumped about?
Para 2.
Oderint Dum Metuant - Let them hate, so long as they fear.
:spyder:'s - I have sincerely now lost count.
http://www.spydiewiki.com/
http://spyderco.com/edge-u-cation/glossary.php
:spyder:'s - I have sincerely now lost count.
http://www.spydiewiki.com/
http://spyderco.com/edge-u-cation/glossary.php
- Jim Malone
- Member
- Posts: 1342
- Joined: Thu Aug 18, 2005 5:31 pm
- Location: Absurdistan E.U.
Mr. Blonde's site and this forum. Most of the 'hints' about upcoming models are posted in Sal's casual bombshells thread, and after blade show or the other knife shows there is normally a lot of discussion about what knives were shown.Evil D wrote:Where can a noob like me see/read about prototypes?
Another site worth keeping an eye on is Knifecenter's blog.
- P40_Warhawk
- Member
- Posts: 190
- Joined: Thu Apr 29, 2010 9:06 am
- Location: Westchester County, NY
- PureSeventyNine
- Member
- Posts: 62
- Joined: Wed Feb 17, 2010 12:28 am
- Location: Brandon, Florida, USA, Earth
- tanrichguy
- Member
- Posts: 191
- Joined: Tue Jun 15, 2010 3:33 pm
- jabba359
- Member
- Posts: 4958
- Joined: Fri Feb 10, 2006 11:07 pm
- Location: North Hollywood, CA U.S.A. Earth
- Contact:
Yep. Sal posted this in early May, referring to the G-10 version.Evil D wrote:Any news of the Native 4 FRN yet? I've been searching and can't find anything since around '08
So it sounds like they are working the kinks out, and once everything is working fine on the G-10 version, they will then produce the molds for the FRN version. So we might have a little while to wait, as the G-10 version isn't out yet.sal wrote:We're doing a "pilot" run now. Probably still a few months off.
This will be a major change in the design and we'd like to make sure we get it right. Refining and improving the lock-back geometry has been challenging.
Once the pattern is nailed down, We'll be making new molds for the FRN version.
sal
-
- Member
- Posts: 63
- Joined: Sun Mar 22, 2009 11:48 pm
- defenestrate
- Member
- Posts: 2656
- Joined: Fri Sep 24, 2004 10:33 am
- Location: RTP NC area
- Contact:
Man i can't wait. For whatever reason out of all the knives i've handled the Native just feels best in my hand. The only thing i could ask for is either make the 2nd finger groove deeper so more of the spyderhole is exposed for easier opening, or raise the spine of the blade some to get the same effect.jabba359 wrote:Yep. Sal posted this in early May, referring to the G-10 version.
So it sounds like they are working the kinks out, and once everything is working fine on the G-10 version, they will then produce the molds for the FRN version. So we might have a little while to wait, as the G-10 version isn't out yet.
All SE all the time since 2017
~David
~David